The DYNACORD SUB 112 is a vented, direct radiating cabinet, equipped with the high-power DYNACORD DND12S400 neodymium transducer. The conical vent system shows significantly less distortion and lower air noise at low frequencies than common circular vent openings.
Product Ref: 12445
DYNACORDs SUB 112 is a vented, direct radiating cabinet, equipped with the high-power DYNACORD DND12S400 neodymium transducer. The conical vent system shows significantly less distortion and lower air noise at low frequencies than common circular vent openings.
The SUB 112 contains a passive filter, 6 dB/oct., that suppresses high frequencies. Appropriate fullrange cabinets, e.g. DYNACORDs D 8 can therefore be directly connected in parallel to the SUB 112 if an extended bass reproduction is required. You just have to connect the SUB 112 and the D 8 with a regular Speakon cable in parallel.
The SUB 112 cabinet is made of 15mm birch plywood. All corner joints and braces are grooved and glued. The cabinet´s surface is painted with a 2-K laquer finish . The acoustic foam front on a powder coated steel grille protects the DND12S400 woofer against damage during transport and bad environmental conditions. The connector panel uses two 4-pole Speakon connectors (INPUT/THRU) for a safe connection and easy daisy-chaining to other cabinets. The pin assignment is 1+/1-. Pins 2+ and 2- are also connected between the two Speakon connectors. A pole-mount flange allows easy speaker-on-a-stick applications. Please always take care that every speaker stack has been mechanically secured against accidental falling down. Please always consult a certified structural engineer for correct and safe setup methods.
The cabinet is equipped with four large rubber feet. Two handles allow easy and safe transport. A protective cover is available as an optional accessory.
Configuration - Built-In Hi-Cut Filter
Nominal impedance - 8 Ohms
Rated power - RMS 400 Watts
Program power - 800 Watts
Peak power - 1600 Watts
Passive crossover frequency - 124 Hz
Component SUB - DND12S400 Order No. D366712
Connectors - SUB 1+, 1- Wired through 2+, 2-
Connector model - Speakon NL4MPR
Dimensions (WxHxD) mm 545 x 380 x 445 mm
Shipping weight 22 kg
Net weight 20 kg
Enclosure material - Birch Plywood
Finish - 2-Component Paint Grille Powder coated steel, Acoustic Foam
Any electrical items in your order may have been designed to work with a 240V circuit, using a United Kingdom G type plug connection. An adapter or transformer may be required for these items to work properly and safely in your country. Some items work with a range of voltages, or have a switchable voltage control built in. Please refer to the specific product details for further information.