Unsupported Browser
The web browser that you are currently using is no longer supported, and as such features of this website may not work as expected. We advise you to update to a currently supported browser (such as Chrome, Edge, or Firefox) to improve your security, speed, and overall experience.
Key Features
For a Limited Time Only receive a FREE sE Electronics Project Studio Reflexion Filter Vocal Booth RRP 128.00 and an sE Electronics Pro Dual Pop Shield RRP 116.00, Valid While Stocks Last
The Z3300A is our most versatile FET microphone and utilises a large 1.07 twin diaphragm, which gives the engineer a choice of three polar patterns, omni, cardioid and figure of eight.
Image is for reference only and is not to scale
Product Ref: 17823
The Z3300A is our most versatile FET microphone and utilises a large 1.07 twin diaphragm, which gives the engineer a choice of three polar patterns, omni, cardioid and figure of eight.
Couple this with a 100Hz low cut filter and new ultra clean, ultra quiet Z range electronics and the Z3300A is the ultimate solid state microphone for almost all recording applications, from vocals, to pianos and acoustic instruments.
"When you can get this kind of quality so affordably, it seems like false economy to go out and buy a cheaper mic... sE Electronics are on to a winner"Sound on Sound
sE Electronics Z3300a Specifications
Frequency Response: 20Hz-20KHz
Sensitivity: 12.6mV/Pa - 38 ± 2dB(0dB=1V/Pa 1000Hz)
Polar Pattern: Cardioid, Omni, Figure 8
Impedance: = 200 Ohms
Equivalent Noise Level: 20dB(A weighted)
Max SPL for 0.5 THD@1000Hz: 125dB
Power Requirement: Phantom power 48V±4V
Connector: 3-pin
sE Electronics Project Studio Reflexion Filter Vocal Booth
After 3 years and many poor imitations of SE's now industry standard design, they have gone back to the drawing board to produce what many budget concuos customers have so desired... an entry level Reflexion Filter product which actually does the job properly!
Due to patents pending on their original design, competitors who have tried to emulate the success of SE's original RF Pro have not managed to do so succesfuly since their designs are limited, and as a result, so are their performances.
The Project Studio RF uses the same basic design as the Pro version, and while it can never be fully as effective as its more expensive big brother, it easily ouut performs copies and for project studio use is just the job. The metal frame is lined with the same patented polyester fibreboard as the Pro version uses for its outer layer. This material has extremely good acoustic absorbtion properties; much better than simple foam products. This is then further lined with a high density 'crystal' foam with curved undulations rather the cheaper and less effective ribbed, medium density foams that are widely used by other companies.
The result is a product which looks fantastic and 'sounds' even better when recording vocals and acoustic guitars... its not an RF Pro, but it's the best of the rest!